본문 Unit 10 Delta Modulation (DM) Exercise 1. A Linear Delta Modulation (LDM) System Procedure 5. Disconnect the cable attached to OUTPUT B of the Clock Generator and connect it to the Monitor output of the Lowpass Audio Filter located next to the Synchronous Audio Generator. Adjust the cutoff frequency of the lowpass filter to 500Hz. Pull the lowpass audio filters gain knob to the VAR position and adjust the filters gain to obtain a 2V p-p sine wave on channel 1 of the oscilloscope. 6. Use the Select push button in the Selector 1 section of the Signal interruptor/Selector to select SIGNAL 2. Turn the Slope knob on the Delta Encoder clockwise until the waveform on Channel 1 of the oscilloscope approximately resembles the waveform shown in Figure 5-13. Figure 5-13. Channel 1 waveform for setting the Delta Encoders SLOPE CONTROL 8. Reconnect the Audio Outpt of the Lowpass Audio Filter to the Audio Input of the Delta Encoder. On the oscilloscope, select the ALT vertical mode. The oscilloscope display should resemble Figure5-14. Figure 5-14. Correctly adjusted waveforms What is the waveform displayed on channel 1 of the oscilloscope? Delta Decoder의 신호이다. 하고 싶은 말 좀 더 업그레이드하여 자료를 보완하여, 과제물을 꼼꼼하게 정성을 들어 작성했습니다. 위 자료 요약정리 잘되어 있으니 잘 참고하시어 학업에 나날이 발전이 있기를 기원합니다 ^^ 구입자 분의 앞날에 항상 무궁한 발전과 행복과 행운이 깃들기를 홧팅 키워드 실험, 통신, 통신실험, 레포트, 보고, 보고서 |
2019년 2월 1일 금요일
레포트통신실험 Delta Modulation 보고서
레포트통신실험 Delta Modulation 보고서
피드 구독하기:
댓글 (Atom)
댓글 없음:
댓글 쓰기